This page is for all Star Citizen layouts and their diagrams. Feel free to message at the bottom for improvements, problems, and suggestions. Enjoy!
COMING SOON
Th3_Warm0ng3r's
ABOUT MY SETUP
After seeing some of the setups that were out there I found that I wanted to make one a little simpler and keep controls grouped together on what is used most in my opinion. This can be used with or without rudders as roll is used for both and the left/right axis for yaw. If there is a demand for a switch I will create one.
The mouse is disabled during flight due to a glitch. The Space break is both a normal break when pulled back and in essence a parking break if pushed forward keeping it in place even if you get out as far as I can tell.
I have created a nifty little auto landing system using the flaps toggle on the far left of the throttle. When coming in to land first flick the toggle down to engage the landing system, then aim your reticle at the desired landing pad and flick the toggle back to middle. Lastly fly over the landing pad so that it shows on your radar and flick the toggle up to have your ship auto land. If you get back in the ship with the toggle still up and wait for complete startup before resetting to middle it will auto-take off as well!
Make sure you start the game with FLAPS at mid, both ENG OPEN at middle, AUTOPILOT set to ALT/HDG, The TROTTLE FRICTION CONTROL in the middle dead zone, and all other toggles in the down position
INITIAL INSTALL AND SETUP
Current Build: 2.4
Step 1: Download my keyboard settings here to your desktop or other memorable location.
Step 2: Open the file explorer to the Star Citizen Mappings folder. It may vary some but it should be in something like this; This PC > Local Disk (C:) > Program Files (x86) > Cloud Imperium Games > StarCitizen > Public > USER > Controls > Mappings.
Step 3: Place the file Th3_Warm0ng3r_Keyboard.xml into the folder then close the file explorer.
Step 4: If you do not have the T.A.R.G.E.T. software from Thrustmaster download and install it from this direct link. The rest of the software and files related to T.A.R.G.E.T. will be in the Thrustmaster's section.
Step 5: Download the Th3_Warm0ng3r Star Citizen Build (Basic).fcf file here and remember where you place it.
Step 6: Go to the hangar in Star Citizen, once loaded follow these steps to load the keyboard layout.
A) Press ` to open a command screen
B) Type "pp_rebindkeys" then press enter to reset key bindings
C) Type "pp_rebindkeys Th3_Warm0ng3r_Keyboard and press enter, you should see a message saying "%USER%/Controls/Mappings/Th3_Warm0ng3r_Keyboard.xml loaded. Enjoy!"
D) Press ` to close the command screen
Step 7: Exit Star Citizen and load the TARGET GUI software
Step 8: Click the "Run Configuration" button in the top right and load the downloaded file Th3_Warm0ng3r Star Citizen Build (Basic).fcf" and it should switch screens with the last line saying "main returned 0"
Step 9: Start Star Citizen again and all should work!
Also to end TARGET GUI just click the red lined button in the top right saying "STOP PROFILE"
Add Comments and Suggestions at the Bottom!
FLIGHT CONTROLS
Below are the layouts for my setup, both pictures and links for direct download. I have found it best print these out and have them pinned up while getting used to the controls.
